Using Remote Controller; Starting Operation - Hitachi EP-A3000 Instruction Manual

Using Remote Controller

Here we describe how to operate the air purifier using the remote controller. For the operation using the
control on the purifier, please refer to
Remote Controller
Securely insert the power plug into
AC outlet.
Press
Operation starts and the indicators are lit.
Pressing
operation will stop the operation.
The factory setting is "Air Purify" in the Auto Mode.
From the second time onward, the memory function enables the operation with memorized conditions.
P.E-11
Stand-by Power Consumption
So long as the power plug is left inserted in AC outlet, approx. 0.4W power will be consumed even if the unit
is not used. (Unplug the power cord when the unit is left unused for an extended period of time.)
E-8
P.E-11 .

Starting Operation

Air Purifier
button.
button during
Indicator Section
In the first 3 minutes after the power cord is plugged
in, the unit checks the room air condition and saves it
in memory. During the checking period, the "Air Purify"
indicator blinks green. After 3 minutes pass, the blinking
stops and the indicator goes out.
You may start the operation within 3 minutes of plugging
in the unit. In this case too, the "Air Purify" indicator
continuously blinks and, after 3 minutes have passed,
the indicator stops blinking and lights up solidly.
Blinks
The "Auto Mode" and "Airflow Level" indicators
light up. (The "Air Purify" indicator in the Auto
Mode blinks for 3 minutes and then lights up
solidly.)
Lit Lit