Remote Controller - Hitachi EP-A8000 Instruction Manual

Operation Buttons and Indicators /
P.* shows a page in the instruction manual with additional information.
Humidity Level
Indicates approximate humidity level in
the room during operation.
Low
Orange Orange
Humidity Level
Airflow Level
These indicators (green) indicate the airflow rate during operation.
Auto
: Airflow rate during auto operation
: Indicates eco operation is active.
These indicators show the airflow rate
selected using the airflow button on the

remote controller.

: Silent
: Med
: Strong or Max (blinking)
When using the remote controller, point it at the infrared remote receiver on the unit indicator section.
When aimed squarely at the infrared remote receiver, the remote controller can be used at
distances of up to approximately 6 m.
On/Off Button
Press this button to start or
stop operation.
eco Button
Press this button to start or
stop eco operation.
Max Button
Press this button to start
max operation.
Note
Unit Operation Buttons and Indicators
P.E-14, 19
Moderate High
Green Orange Orange
Strong
Air Purify Pollen Deodorization Humidify
Auto
P.E-16
Remote Controller
P.E-14
P.E-21
P.E-17
The remote control may not work in a room where inverter lighting apparatus or electronic quick
start lighting apparatus is used, or when the infrared receiver is exposed to direct sunlight.
The remote controller works best when aimed squarely at the remote infrared receiver. Whenever
possible, use the controller from a point directly in front of the unit.
Operation Mode P.E-15
Shows the operation mode.
Air Purify, Pollen, Strong
Deodorization
Indicator: Green
Humidify, Skin Moisturize
Indicator: Orange
(Approx.)
Skin
Ai r
Moisturize Timer(4hrs)
Sensor r
Clean
Max(Blinking)
Humidifying
Filter
Clean Humidifying
Filter
P.E-22
This indicator (red)
indicates that it is
time to clean the
humidifying filter.
On/Off Button
P.E-18
Press this button to start or stop opera-
tion and to switch the operation mode.
Air Sensor P.E-18
The indicator lights up or flashes
green to indicate the air condition
detected by the dust/odor sensor.
Infrared Remote Receiver
Receives the signal from
the remote controller.
Timer P.E-17
This indicator (green)
lights up when the 4-hour
timer is set.
Airflow Button P.E-16
Press this button to switch
airflow rate.
Mode Button P.E-15
Press this button to switch
operation mode.
Timer Button P.E-17
Press this button to set
Off-timer.
Sensor Setting Button P.E-20
Press this button to switch
sensor sensitivity.
E-3