Inserting Batteries Into Remote Controller; Filling Water Tank - Hitachi EP-A8000 Instruction Manual

Inserting Batteries into Remote Controller

Remove the battery
compartment cover.
Cover

Filling Water Tank

Quietly remove the water tank.
As in the following illustration,
applying your thumb to the top
of the water tank handle,
lift up the bottom to unlock.
When removing the water tank, water adhering to the tank cap may spill,
so lay a dry cloth beforehand.
Remove the tank cap and fill
with clean tap water at room
temperature.
When pressing the pin in the center of
the tank cap, confirm it returns with a spring.
Firmly fix the tank cap parallel to the surface
of the water tank inlet. Wipe off the spilt water
and turn the tank cap upside down to check
that there is no water leakage.
* When carrying the tank, keep the tank cap
upward.
When water collects in the handle of the water
tank, wipe it off.
The tank cap is consumable.
(When water leaks due to deterioration, etc.
of the rubber packing, purchase the tank cap,
a part separately sold to replace
Insert batteries and close the cover.
Insert the two provided "AAA" R03 batteries with the
correct polarities as instructed.
Since the batteries are provided when shipped from
the factory, their lives may be shorter than brand new
batteries due to self discharge.
Batteries are consumable items.
When replacing batteries, replace two batteries simultaneously.
Only use two manganese batteries or two alkali batteries.
Do not mix different types of batteries.
(for Humidify Mode and Skin Moisturize Modes)
Pull the water tank toward you and remove it.
Handle
Water tank
CAUTION
Rubber packing
)
P.E-32
Ensure the rubber packing is installed to
the tank cap.
Tank cap
Loosen
Handle
Water inlet
Press in the cover until
it clicks.
Do not press in
the pin in the
Tighten
center of the
tank cap.
Doing so may
result in water
leakage.
Pin
E-11