HP C2858A Service Manual page 42

Message
Pen palette
saved
Returning pens
Roll feed
Edge trim
RS-232 config
loaded
RS-232 config
saved
STATUS
Initializing
STATUS
Out of media
STATUS
Plotting
STATUS
Ready for media
STATUS
Ready to plot
STATUS
Receiving
Testing pens
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
Table 3-2. State Messages (Continued)
State
The pen source, pen number widths, and pen number shades you just en-
tered have been saved as either Palette A or Palette B (whichever you
specified).
The pen carriage is returning to its station at the left of the plotter.
Machine is trimming the edge of roll media.
The RS-232-C configuration you just entered (Config A, Config B, or
Factory) has been loaded.
The baud, handshake, and parity settings you just entered for your
RS-232-C configuration have been saved as either Config A or Config B
(whichever you specified).
Machine is doing internal checking upon power-up.
The plotter has detected that the roll is empty (you must be in Roll mode
for this to happen). If desired, remove the old roll and insert a new one.
Machine is plotting.
Machine is ready for you to load media.
Machine is ready to plot.
Machine has received plot data.
The machine is testing the pens for problems, i.e., clogged pen or bad
electrical connection (improper seating).
Installation and Configuration
3-23