GE ADQ12 Owner's Manual And Installation Instructions page 12

3 REMOVE THE AIR CONDITIONER
FROM THE CASE
Remove and discard the 2 shipping screws
A
from the bottom rear of the case.
Grasp the filter tab at the bottom center of
B
the grille and pull the filter down and out.
On models with control knobs, remove them
C
by pulling them straight off their shafts.
Grasp the lower corners of the grille frame
D
while pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the
bottom edge toward
you more than 3 " or
you may damage the
tabs of the grille.
Installation Instructions
12
3 REMOVE THE AIR CONDITIONER
FROM THE CASE (CONT.)
On some models, you must also
E
disconnect the control connectors before
the grille frame can be removed. Press the
locking tabs in while pulling on the other
side to release.
Remove the locking screw and locking
F
bracket from the lower frame.
Remove the screw and washer securing
G
the ground wire to the right side face of
the unit.
Washer
Slide the air conditioner from the case by
H
gripping the base pan handle and pulling
forward while bracing the case.
Press in
Pull
Press in
Ground wire
Screw