GE ADQ12 Owner's Manual And Installation Instructions page 15

6 INSTALL A SUPPORT BRACKET
AND THE FOAM TOP WINDOW
GASKET
Attach a support bracket with a Type C
A
screw.
Cut the foam top window gasket to the
B
window width.
Stuff the foam between the glass and the
C
window to prevent air and insects from
getting into the room.
INSTALL THE AIR CONDITIONER
7
IN THE CASE
Slide the air
A
conditioner into
the case. Do not
push on the
controls or the
finned coils.
Make sure the
air conditioner
is firmly seated.
Reinstall the locking bracket and screw
B
removed earlier.
Installation Instructions
15
7 INSTALL THE AIR CONDITIONER
IN THE CASE (CONT.)
Reconnect the ground wire to
IMPORTANT!
C
the air conditioner with the washer and
screw removed earlier.
Washer
If your model has the
D
control connectors,
reconnect them to the
front grille by pressing
them together until the
locking tabs snap into place.
Attach the front grille frame to the case by
E
inserting the tabs on the grille frame into the
slots on the front top of the case. Push the
grille frame in until it snaps into place
around the power cord on the right side.
Guide the levers carefully
through the grille frame as
you push it in.
On models with control knobs, replace
F
them by aligning them on their shafts and
pushing them firmly into place.
Secure the front grille frame to the case with
G
a Type B screw.
Install the filter. Connect power.
H
Ground wire
Screw