This sequence can be performed according to the messages shown on the operation panel only when a specific type of media is selected after selecting the manual

feed mode from the menu shown on the operation panel. When a cut sheet is loaded according to the message shown on the operation panel, the printer performs

various adjustments and detection using the multi sensor and then feeds the cut sheet to the rear of the printer. At this time, the multi sensor detects skewed feeding

and leading edge of the cut sheet, thus completing the paper pick-up operation.

During printing, the cut sheet is fed by controlling the rotation of the feed roller according to the selected print mode.

2.3.3.2.7 Manual Feed (from Rear) Sequence

This sequence can be performed according to the messages shown on the operation panel only when a specific type of media is selected after selecting the manual

feed mode from the menu shown on the operation panel. When the cut sheet loaded at the back of the printer is detected by the sensor, the printer starts feeding the

cut sheet. After this, the printer performs various adjustments and detection using the multi sensor, thus completing the paper pick-up operation.

During printing, the cut sheet is fed by controlling the rotation of the feed roller according to the selected print mode.

The auto roll feed unit starts feeding the cut sheet when the roll media detection sensor detects the media.

When the auto roll feed unit is not mounted, the printer starts feeding the media when the paper detection

sensor detects the media.

2-40

Cut sheet loading

(manual)

Light intensity/

Head hight adjustment

Detection of paper width

Back feed