Motor Driver; Roll Feed Unit Pcb Components; Maintenance Cartridge Relay Pcb; Maintenance Cartridge Relay Pcb Components - Canon iPF600 series Service Manual

2.4.4 Motor Driver

2.4.4.1 Roll feed unit PCB components

a) Driver IC (IC1)
Roll motor drive function
This function controls the roll motor based on the control signals from the main controller.
Sensor relay function
This function relays the input signals from the roll cam sensor and roll media sensor to the main controller PCB.

2.4.5 Maintenance Cartridge Relay PCB

2.4.5.1 Maintenance cartridge relay PCB components

a) EEPROM (IC1)
The 128-KB EEPROM stores all information written to the EEPROM on the main controller PCB.

2.4.6 Power Supply

2.4.6.1 Power supply block diagram

Operation panel
POWER ON
The power supply converts AC voltages ranging from 100 V to 240 V from the AC inlet to DC voltages for driving the ICs, motor, and others.
The voltage generator circuits include the +26 V generation circuit for driving motors, fans, and sensors and a +21.5 V generator circuit for driving sensors, heads,
logic circuits, and others.
When the power is turned off, +26 V and +21.5 V are reduced to about 12 V and 9 V respectively (power save mode).
Power ON/OFF operation is controlled by the main controller PCB.
IC 1
F-2-48
IC 1
F-2-49
Main controller PCB

Power supply

DC power supply
control circuit
+5V/+3.3V
generation circuit
F-2-50
+26V
generation circuit
Transformer
+21.5V
generation circuit
Chapter 2
AC inlet
100V to 240V
Noize filter circuit
Rectifying circuit
0013-4323
0013-5143
0013-4333
2-49