Technical Specification - Philips AZ1009 Service Manual

TECHNICAL SPECIFICATION

General:
Mains voltage : 220V-230V / 50Hz for /00 /04 /14
230V-240V / 50Hz for /05 /10
110V-127V / 220V-240V /50Hz switchable for /01 /11 /11H
120V / 60Hz for /17
Battery : 9V ( 6xR20 )
: ≤ 15W at maximum output power, ( ≤ 11W at 1/8 P
Power consumption
≤ 5W (typ. 2W) with source switch in tape/off
Amplifier:
Power stage protection : temperature and shortcircuit
Output power mains : 2 x 1,4W
battery : 2 x 2W
: 3,5mm stereo jack, ≥ 20mW at 32Ω (≡ 0,8V at 32Ω ) D=10%
Headphone
: 30Hz - 16kHz ( typ. at volume set to -20dB, CD mode 0dB signal level ⇒use SBC429 )
Frequency response
Tone control DBB : +12dB ±3dB at 100Hz ( volume set to -20dB )
Tuner:
Tuning range
IF
Sensitivity
Mono: 26dB S/N, m=30%
-3 dB limiting point
AFC capture range
Distortion
Image rejection ratio
Channel separation at 1kHz
CD:
To be measured on phone socket with 100kΩ load.
Frequency response : 30 - 16.000 Hz -4dB
≥ 60dB
Signal/Noise ratio :
Distortion : 0.2% typ. at 1 kHz
≤ 3dB at 1 kHz
Channel difference :
Channel crosstalk : 40dB typ.
De emphasis : 0 or 15/50µs switched automatically by subcode on the disc
Laser
Output power : 500µW
Wave length : 780 ± 20 nm
Recorder:
To be measured on phone socket with 100kΩ load.
Tape speed
Wow & Flutter
Winding speed
Erase / Bias system
Distortion at 250 nWb/m
Signal/Noise ratio
(FF weighted)
(A - weighted)
Channel difference at PB
Channel difference overall
Channel separation
Track separation
Frequency response IEC I
Pb
overall
note: set is not prepared to play or record IEC II Chrome cassettes!
CS 49 102
-1dB at 4Ω D=10%
rms
-1dB at 4Ω D=10%
rms
FM
87,5 - 108 MHz
10,7 MHz ± 20 kHz
≤ 4 µV ( ≤ 2µV typ.)
≤ 5 µV ( ≤ 2µV typ.)
±300kHz typ.
≤ 7% (≤ 1% typ.)
RF=1mV ∆f=75kHz
≥ 20dB (26dB typ.)
≥ 20dB (25dB typ.)
: 4,76cm/s ±3%
: ≤ 0,5% weighted
: 120s for C60 cassette
: permanent magnetic erase head / AC 65 ±5kHz
: ≤ 7%
: ≥ 40dB
: ≥ 43dB
: ≤ 5dB
: ≤ 5dB
: ≥ 15dB at 1kHz
: ≥ 55dB at 1kHz
: 125Hz - 8000Hz (within 8dB)
: 250Hz - 6300Hz (within 8dB)
2-1
)
max
MW
522 - 1607 kHz
(520 - 1730 kHz for /17)
468 kHz ± 3 kHz
≤ 4mV/m (≤ 1,5mV/m typ.)
≤ 7% (≤ 2,5% typ.)
RF=100mV/m m=80%
≥ 28dB