Frigidaire FAX050S7A-A Product Information And Technical Manual page 3

IMPORTANT SAFETY UPDATE
Room Air Conditioners manufactured after August 1
with a new industry regulated power cord with either of the following in
the plug-head or in line:
LCDI: Leakage Current Detection Interrupter
AFCI: Arc-Fault Circuit Interrupter.
All Frigidaire products have an LCDI located in the plug head or in-line.
The power supply cord contains a current device that senses damage to
the power cord. To test your power supply cord does the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST
button. You will notice a click as the RESET button pops out.
3. Press the RESET button. Again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some products
this is also indicated by a light on the plug head).
Notes:
Do not use this device to turn the unit on or off.
Always make sure the RESET button is pushed in for correct operation.
The power supply cord must be replaced if it fails to reset when either the TEST
button is
obtained from the product manufacturer.
If power supply cord is damaged, it CANNOT be repaired, it MUST be replaced by
one obtained from the product manufacturer.
pushed, or it cannot be reset.
3
st
, 2004 are equipped
A new one can be