Service Mode 1; Service Mode 2; Table 6-85: G 879 Program Sequence Chart - Miele G 600 Series Technical Information

Technical Information
2. Press and hold program buttons 1 and 2 while turning the dishwasher on. A
flashing On/Off light indicates successful accessing of Service Mode 1.
3. Place the see-through door onto the dishwasher.
4. Select a program and trip the door lock with a screwdriver or Miele tool C6042.
The selected program will start.
5. Pressing the Top solo button repeatedly will allow the technician to advance
through the program. If the Top solo button is not pressed, the program steps
are carried out automatically, in their normal order.
Note:
The program chart in the wiring diagram should be used to follow the machine
functions when stepping through a program.
Note:
If not using the see-through door, access Service Mode 1 as above. Close the
dishwasher door. After the program starts, open the door and use program button 6
to select the appropriate program step. The program step that the dishwasher is
currently in will be displayed by the illuminated program button lights. Each light
corresponds to a binary number (see the program sequence chart, Table 6-85).
Add the numbers represented by the lights to arrive at the program step. When the
appropriate step has been reached, the door can be closed and the program will
continue.
Program button light 1
Binary number

Table 6-85: G 879 Program Sequence Chart

Example: Program button lights 2 and 5 are lit.
Program button light 2 = Binary code 16
Program button light 5 = Binary code 2
16 + 2 = Program step 18
Note:
The program chart in the wiring diagram should be used to follow the machine
functions when stepping through a program. As long as the dishwasher is in
Service Mode 1, the program buttons will indicate the program step in binary code.
6.8.15.2.1 Test Program
The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Press program button 5; the test program will start and advance automatically.
3. Pressing the Top solo button repeatedly will allow the technician to advance through the
program.
4. If the Top solo button is not pressed, the program will run automatically.
6.8.15.3

Service Mode 2

Service Mode 2 is used to determine which upper electronic is in the appliance, to
change certain programmed functions and to access fault codes. The programmed
Program Sequence Chart
2 3
32 16 8
4 5 6
4 2 1
136
G 600/G 800