Waterproof System (Wps) Removal; Waterproof System (Wps) Restrictor Replacement; Figure 5-21: Pressing And Locking The Filter Assembly; Figure 5-22: Tilting The Flow Restrictor - Miele G 600 Series Technical Information

Technical Information

Figure 5-21: Pressing and Locking the Filter Assembly

Note:
Use caution to ensure that the filter is not damaged during re-assembly.
8. Re-install the filter.
5.24

WaterProof System (WPS) Removal

1. Remove the drip pan. See Section 5.29.
2. Release the hose clamp tension and remove the intake hose from the flow meter
(or water intake assembly).
3. Disconnect the electrical connection to the solenoid valve (Y2) located near the
front of the water softener salt tank.
4. Release the locking collar tension on the back of the dishwasher and remove the
WPS by pulling outwards.
Note:
The new WPS is supplied with various flow restrictors. Ensure that the correct flow
restrictor (color-coded) is installed.
5.25

WaterProof System (WPS) Restrictor Replacement

1. Shut off the water supply.
2. Disconnect the WPS at the plumbing supply connection.
3. Remove the sealing washer and filter from inside the WPS connection.
4. Using a 5mm nut driver, press and tilt the restrictor to the side (see Figure 5-22).

Figure 5-22: Tilting the Flow Restrictor

60
G 600/G 800