5-2. CIRCUIT BOARDS LOCATION
A
H
D
5-5
5-3. SCHEMATIC DIAGRAMS AND PRINTED
WIRING BOARDS
Note:
• All capacitors are in µF unless otherwise noted. (pF: µµF)
Capacitors without voltage indication are all 50 V.
• Indication of resistance, which does not have one for rating
electrical power, is as follows.
Pitch: 5 mm
Rating electrical power 1/4 W (CHIP : 1/10 W)
• All resistors are in ohms.
f
•
: nonflammable resistor.
F
•
: fusible resistor.
¢
•
: internal component.
p
•
: panel designation, and adjustment for repair.
• All variable and adjustable resistors have characteristic curve B,
unless otherwise noted.
e
•
: earth-ground.
E
•
: earth-chassis.
• All voltages are in V.
• Readings are taken with a 10 MΩ digital multimeter.
• Readings are taken with a color-bar signal input.
• Voltage variations may be noted due to normal production
tolerances.
•
: Can not be measured.
*
• Circled numbers are waveform references.
s
•
: B + bus.
S
•
: B – bus.
[
• The components identified by
in this basic schematic diagram
have been carefully factory-selected for each set in order to
satisfy regulations regarding X-ray radiation.
Should replacement be required, replace only with the value
originally used.
]
• When replacing components identified by
, make the
necessary adjustments indicated. (See page 3-1)
• When replacing the part in below table, be sure to perform the
related adjustment.
[
Part Replaced (
)
HV ADJ
RV501
]
Part Replaced (
)
HV Regulator
D board IC502, IC503, Q511,
Circuit Check
D510, C535, R515,
R554, R559, R560,
R596, RV501,
T501 (FBT)
HV Hold-down
D board IC501, R598, R599,
T501 (FBT)
Circuit Check
Beam Current
D board T501 (FBT)
Protector Circuit
Check
• Divided circuit diagram
One sheet of D board circuit diagram is divided into three
sheets, each having the code D-a to D-c . For example, the
destination ab1 on the D-a sheet is connected to ab1 on the
D-b sheet.
a
b
1
Ref. No.
Circuit diagram division code
Note: The components identified by shading and mark
! are critical for safety. Replace only with part
number specified.
Note: Les composants identifiés par un tramé et une
marque ! sont critiques pour la sécurité. Ne les
remplacer que par une pièce portant le numéro
spécifié.
5-6