Advertisement
PRIMUS BUSINESS SERVICES
GUIDE
Registering the Repeater to Another Repeater
A repeater can be connected to another repeater in series to extend total coverage
to up to 150m. This can be done by registering the repeater to another repeater.
In the diagram above, the destination repeater is registered with the base unit, and
the origin repeater is connected in series to the destination repeater. This section
describes how to set up the origin repeater. Before you begin, you must
register the destination repeater to the TGP600 base unit. Please follow the
steps in the previous section on how to register a repeater to the base unit.
To register a repeater to another repeater, they must be set to the same ID.
On the destination repeater:
1. First check the ID of the repeater you are attempting to register to
(destination repeater). With the destination repeater turned on and
functioning normally, press the PROGRAM button located under the
destination repeater. Note the number of times the
green. This is the ID of the destination repeater – one flash indicates the ID
as 1, two flashes indicate the ID as 2, and so on.
2. Return the destination repeater back to normal operation by pressing the
PROGRAM button again. Both the
back to
solid
green.
On the origin repeater:
3. Turn on the repeater you want to register (origin repeater) by connecting the
AC adaptor. The STATUS indicator should be
indicator should be off.
4. On the origin repeater, press and hold the PROGRAM button for 5 seconds
until the STATUS indicator
|
|
HOSTED PBX
PANASONIC A406 REPEATER QUICK SETUP
(Destination
(Origin
Repeater)
Repeater)
and STATUS indicators should go
flashing red
flashes
green. Release the PROGRAM button.
indicator flashes
and the
PRIMUSBUSINESS.CA
4
Advertisement
