Install The Microphone - Motorola MOTONAV TN500 Series Installation Manual

6 Reconnect battery to vehicle.
Failure to follow these steps may cause the harness
not to work properly and could damage the harness.
install with third-party vehicle
specific harness
Some vehicles require a vehicle-specific harness (not
supplied) that allows integration of the harness into
the vehicle entertainment system. The connectors on
the ISO interface cable are designed to connect
directly to such a third-party harness. If you choose to
use a vehicle-specific harness, follow the guidelines
that came with the harness.

install the microphone

Caution: The location of the MOTONAV device must
not interfere with the vehicle's air bag deployment.
Also, the microphone cable should not pass in front of
or interfere with the deployment of any vehicle
airbags. In particular, side airbags located with the
windshield pillar or door jamb.
1 Mount the microphone in a suitable location using
either the screw, velcro, or clip.
• The preferred spot to mount the microphone
is on the overhead console/dome light
assembly near the front center of the vehicle,
away from the window, pointed toward the
driver's mouth.
• Locate the microphone no more than 16
inches (40 cm) from the driver.
• Do not allow anything (such as a rear-view
mirror or sun visor) to block the path between
the microphone and the driver.
• Mount the microphone firmly so that
vibrations do not affect audio quality.
• Refrain from locating the microphone directly
in the path of heat/AC vents.
install the car kit 7