Electronic Board Operations Check - Panasonic UB-5320 Operating Instructions Manual

Electronic Board Operations Check

After assembling the electronic board, perform the procedures presented in the following table to make sure it
functions properly.
Step
1 Turn on the power switch.
2 Open the printer door and load the
copy paper, then close the printer
door.
• Loading Copy Paper procedure
(refer to the Operating
Instructions on page 10)
3
Press .
4
Use the accessory marker to
draw a large
entire copyable area of the
screen film surface.
•Copyable area (refer to the
Operating Instructions on
page 7)
Press twice.
Press
5
Press
film surface. Write letters, etc.
with the marker.
Press once.
Press
6
Press once.
7
Press .
36
" " flashes after " " lights
up.
(If not)
" " lights up after the copy
paper is fed and
automatically cut.
(If not)
Screen is fed.
The screen film surface is not
fed smoothly.
There are strange noises.
" " lights up and three
copies are made.
filling the
Three copies are not made.
The entire readable area is
not printed.
There are strange noises or
paper jams during the
copying process.
.
The Contrast indicator light is
to move the screen
turned on and one copy is
made.
The Contrast indicator light is
not turned on.
.
The image is not copied
properly.
There are strange markings
on the copy sheet (e.g.,
stripes or lines).
The Contrast indicator light is
turned off.
(If not)
Two screens are copied
properly.
(If not)
Points to Check
Symptom
(Normal operation)
Check power cord. (See step
16 on page 34.)
(Normal operation)
Check the condition of printer
door or copy paper roll.
(Normal operation)
Contact the store or dealer
from which the unit was pur-
chased.
(Normal operation)
Contact the store or dealer
from which the unit was pur-
chased.
(Normal operation)
Contact the store or dealer
from which the unit was pur-
chased.
(Normal operation)
Contact the store or dealer
from which the unit was pur-
chased.
(Normal operation)
Contact the store or dealer
from which the unit was pur-
chased.
Solutions