Siemens Extraklasse 1300 Instruction Manual And Installation Instructions page 36

Fault
Spin result unsatisfactory. Less Ironing" button pressed
p
Repeated spinning.
The programme takes
longer than usual.
Unsatisfactory washing
result.
Detergent residue on the
laundry.
Grey residues on the
laundry.
Display 0:00",
appliance is still washing
(Wash" indicator light
illuminates)
Changes in the Finish
In" time while the
programme is running.
Reduction in the Finish
In" time
36
Cause
y
The Rinse" or Spin" programme selected
Page 19.
This is not a fault.
The imbalance compensation system is attempting to balance the load
through repeated spins.
This is not a fault.
Imbalance compensation system
attempts to balance the laundry by
repeated distribution.
The foam detection feature has
activated an additional rinsing cycle
to reduce the amount of foam.
The degree of dirt was higher than
supposed.
Not enough detergent.
Some phosphate free detergents
contain water insoluble residues
that may appear as light spots on
the laundry.
Dirt accumulation from ointments,
fats or oils.
This is not a fault.
Additional options were selected after the programme had started. The
Finish In" is corrected in the next programme section Rinse".
This is not a fault.
For this, see also the explanations under: Finish In / Delay Start" displays
and Delay Start" button, page 21.
This is not a fault.
For small amounts of laundry, a reduction in time of approx. 20 minutes
can result, depending on washing programme.
Action
maximum spin speed of 800 r.p.m.
maximum spin speed: see
Wash large and small items
together in order to reduce the
imbalance.
Add a more appropriate amount of
detergent next time.
Select suitable programme
Add detergent according to the
manufacturer's specifications.
Select Rinse" immediately or brush
out the washing after drying.
Add the maximum amount of
detergent and select the highest
permissible temperature next time.