Step 2: Connections - Sony KP-41T25 Operating Instructions Manual

Step 2:
Connections
Although you can use either an indoor antenna or
outdoor antenna with your projection TV, we
recommend connecting to an outdoor antenna or a
cable TV system for improved picture quality.
To an antenna
Connect your antenna cable to the VHF/UHF antenna
terminal. If you cannot connect your antenna cable
directry to the terminal, follow one of the instructions
below depending on your cable type.
A
• VHF only
75-ohm coaxial cable
or
• VHF/UHF
or
• Cable
B
• VHF only
300-ohm twin lead cable
or
• UHF only
or
• VHF/UHF
Antenna connector
75-ohm coaxial cable
C
• VHF
and
• UHF
300-ohm twin lead cable
Notes
• Most VHF/UHF combination antennas have a signal splitter.
Remove the splitter before attaching the appropriate connector.
• If you use the U/V mixer, snow and noise may appear in the
picture when viewing cable TV channels over 37(W+1).
6 -EN
Getting Started
(Rear of projection TV)
VHF/UHF
(Rear of projection TV)
VHF/UHF
(Rear of projection TV)
VHF/UHF
EAC-66 U/V mixer
(not supplied)
Connecting an antenna/cable TV
system without a VCR
To cable or antenna
Cable
To cable box
If your cable company requires you to connect a cable
box, make the connection as follows:
Cable
IN
Cable box
To cable box and cable (KP-41T25 only)
Cable box
75-ohm coaxial cable
(not supplied)
CATV cable
Pay cable TV systems use scrambled or encoded
signals requiring the cable box* in addition to the
normal cable connection.
* The cable box will be supplied by the cable company.
Note
• You cannot watch the signal through AUX connector as a
window picture.
To cable and antenna (KP-41T25 only)
CATV cable
Antenna cable
Note
• Do not connect anything to the TO CONVERTER connector in
this case.
(Rear of projection TV)
VHF/UHF
(Rear of projection
TV)
VHF/UHF
OUT
(Rear of projection TV)
AUX
TO
CONVERTER
VHF/UHF
(Rear of projection TV)
AUX
TO
CONVERTER
VHF/UHF