Making Antenna Connections - Sony KP-46XBR25 Operating Instructions Manual

Making Antenna Connections
Although you can use either an indoor or outdoor antenna with the projection TV, an outdoor antenna will
provide you with better picture quality.
You can receive cable TV by connecting a cable supplied by your local cable company.
Ofolalal-iea(inio mM dnl ar Cla lam olan dul ad Opal amoceyatloyiatsbelelam-tel(ciatit-Lamelal OF-W—\Mets]0)(-1
Check your antenna cable type. If you have 75-ohm coaxial cable (round), attach an F-type connector (not
supplied). If you have 300-ohm twin-lead cable (flat), attach a 300-75 ohm adaptor {not supplied).
Using 75-ohm coaxial cable (round)
Prepare the end of the cable by attaching the F-type
connector as shown below.
7mm (Y%inch) 10mm (% inch)
F-type connector
—_F- 2 -oTp
cr
Plug the connector into the VHF/UHF terminal at the
tear of the projection TV.
VHF/UHF
(Rear of projection TV)
* Most combination antennas are equipped with a signal splitter. .
Remove the splitter and attach the appropriate connector.
Using 300-ohm twin-iead cable (flat)
Prepare the end of the cable by attaching the 300-75
ohm adaptor as shown below.
300-75 ohm
of the projection TV.
2 Piug the adaptor into the VHF/UHF terminal at the rear
Caper setroUe | 4.3
Suenseuue) euuswuy Gupey
s20;9eUUND pus SoU BuNeDO) -