Table of Contents
Advertisement
Connecting Other Equipment —
After making these connections, you will be able to do the following:
View the playback of video tapes
¢RecordTV programs
Record one TV program while viewing another program
Connecting a VCR, video disc player or Camcorder equipped with an S video output jack
<=: Signal flow
(Rear of projection TV)
to S video input "| T
tr
to VHF/UHF
YC-15V/30V
(not supplied) 4
to
to VHF/UHF output
To operate the video equipment, refer to the instruction
manual that comes with the equipment.
You can operate a Sony VCR or video disc player, or
a non-Sony VCR with the supplied Remote Commander.
For details, see "Using the Programmable Remote
Commander" (pp. 74 — 81).
1. Turn on the projection TV.
2 Set S-VIDEO to "ON" (p. 54).
@ Press TV/VIDEO on the projection TV or on the Remote
Commander so that "VIDEO 1," "VIDEO 2" or "VIDEO 3"
appears on the screen.
About S video input
" yuswid
sem
Gunseun0g
- suooouu0)
euusjny
Oupeyy .
VIDEO 1: for equipment connected to VIDEO 1 IN
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
To return to TV mode
Press TV/VIDEO or CHANNEL +/-~ on the projection TV,
or press TV/VIDEO, CH +/— or 0 - 9 and ENTER on the
Remote Commander so that a channel number appears
on the screen.
Note
You can watch both a TV and a VCR image at once, using
Picture-in-Picture (pp. 45 - 49).
Video input and output signals can be separated into Y
(luminance or brightness) and C (chroma or color) signals.
Usually these two signals are combined in a VCR and sent
as one signal to a projection TV. Separation of the Y and C
signals prevents them from interfering with one another,
thereby improving picture (especially color) quality.
This projection TV is equipped with S video input jacks
through which these separated signals can be input directly.
Chapter 1: Setting Up | 15
Advertisement
Table of Contents
