Panasonic NC-ZA1 Operating Instructions Manual page 15

2
Turn the power on.
Plug in and press the power button.
1
• Make sure the waste container, water tank, drip tray and stainless steel plate are fitted.
• Open the drip tray by pressing it. (Attention for drip tray display will show for 3 seconds after the espresso machine is
heated up.)
Heats up the machine
automatically.
Press to start rinsing.
2
• Make sure the drip tray is opened. Otherwise hot water will dispense onto the countertop.
When rinsing is complete (dispense hot
water 4 times), the display will return to
the main menu. Wait until the display
shows the main menu.
Note
• When starting up for the first time or when the water tank was
completely emptied, water suction may take a little longer dispensing
hot water for rinsing cycle.
• A small amount of water can get into the waste container during each
rinsing cycle. This is system-related and not a fault.
• If is pressed during the rinsing cycle, it immediately stops
the process.
After flashes, the display will return to the previous display.
• When dispensing hot water into the drip tray during rinsing cycle, you
may place the container under the dispenser.
• During the rinsing, water is to collect in the drip tray.
When water is full in the drip tray, the red float will be float up.
• If the drip tray is closed with the red float is float up, the red float may
be stuck inside. Try to open the drip tray by pressing it. If it still does
not open, remove the water tank and waste container and press down
the red float through the opening to remove the drip tray.
Float
EN15