Hot Water - Panasonic NC-ZA1 Operating Instructions Manual

Hot water
Preparations: Fill the water tank with water.
1
(P. EN14)
Operate rinsing cycle.
2
• Make sure the milk hose is not attached.
1
Select "hot water" on the main menu.
Then place a cup(s) under the spout.
2
Select the number of cups and adjust quantity.
• The selected cup will light up in blue.
• If adjustment is unnecessary, move on to the step 3.
• Press or
3
Press
O When brewing is completed, display will return to the main menu.
Wait until display shows the main menu to remove the cup(s).
Q To turn off the power after use « P. EN25
EN24
repeatedly to adjust quantity for hot water.
to start brewing.
Note
• If simple rinsing is skipped after milk menu, milk residue may mix into
the hot water. (Step 7 on P. EN21)
In that case dispense the hot water a few times.
Note
• If is pressed, the display will return to the previous menu.
Note
• If is pressed, the display will return to the main menu.
• If is pressed during the brewing process, it immediately
stops the process.
After flashes, the display will return to the main menu.