D-Link mydlink DNR-202L Quick Install Manual page 4

Setup Wizard - Mac OS X
Step 1:
Connect the included Ethernet cable to the Ethernet port located on the rear
panel of the DNR-202L and attach it to your network.
Step 2:
Connect the power supply to the power connector located on the rear panel of
the DNR-202L and connect it to a wall outlet or power strip. Power is confirmed
when the blue LED Power Indicator located on the front panel is lit.
Step 3:
Visit http://mydlink.com/support and download the Mac OS Setup Wizard. Open
the SetupWizard file and launch the Wizard.
Step 4:
Double-click the DNR-202L Setup Wizard file to start the Setup Wizard. When
the wizard appears, click the Start button to begin and follow the instructions
to set up your NVR. If you want to add cameras to your previously-configured
DNR-202L, click the Skip button.
Note: Ensure that cameras have been installed on the network before initiating the
DNR-202L setup.
4