Automatic Answering - Panasonic KX-TD500 System Reference Manual

5.00 Automatic Answering

Selection
This feature automatically connects a PITS
telephone to a pre-assigned line when an
extension user lifts the handset or press the SP-
PHONE to answer incoming calls.
There are two options by which an extension user
may select a desired line:
• Ringing Line Preference-Answering (Default)
• Prime Line Preference-Answering
Operation
To enter into the programming
mode
1. Set the MEMORY switch at
the rear of the PITS to
PROGRAM.
SET• • PROGRAM
MEMORY
• With DPITS, press the
PROGRAM button.
2. Dial "01".
3. To change the preset
feature, dial the program
number corresponding to the
desired feature.
• To set "No Line Preference",
dial "1".
If "No Line Preference-Answering" is selected, no line
is connected to a PITS telephone by lifting the
handset or pressing the SP-PHONE button.
For further information about this feature, refer to
Section 4-D-1.00 "Line Selection-Answering".
The table shows the operation for each programming.
(The explanation of the message display applies only
to a PITS provided with the display.)
Result
• The following message
appears on the display:
PITS-PGM No.?
• The MEMORY button indicator
lights red.
• Preset data appears on the
display:
<Example>
When "No Line Preference" is
preset:
Pref. In : No.
• The following message
appears on the display:
Pref. In : No.
13-C-23
Comment/Note
• This display is called "Initial
display for PITS-station
programming mode".
• If the following message
appears on the display, the
programming data of your
PITS has already been
accessed by another
administration device:
Already Accessed
• If the END button is pressed
while programming, the above
message appears on the
display again.
• If nothing is entered within one
minute after dialing "01", the
"Initial display for PITS station
programming mode" is shown
on the display again .
• To change the assignment,
simply dial the appropriate
number again.
Continued