Panasonic KX-TD500 System Reference Manual page 953

Description of Assigning Items
Tenant Service
Numbering Plan
Privacy on DN Key
DSS Operation Mode
Busy Tone
Held Call Reminder
Beep Tone for Bsy-ovr/
Brg-in
External Paging 1, 2
External Music Source 1, 2
Idle Line Preference
FDN for General
Operator Call
PBX Code
Enables or disables the Tenant Service feature.
Selects the type of numbering plan; The user can assign the desired
feature numbers or use the default setting 1 or 2.
Determines whether or not a PITS telephone user is allowed to barge in
on an existing conversation on a PDN, SDN or SCO button.
When "With Transfer" is selected, allows the DSS console operator to
transfer the CO call to an extension user by simply pressing the associ-
ated DSS(DN) button on the DSS console.
When "Without Transfer" is selected the CO call is disconnected when the
DSS(DN) button is pressed.
Selects busy tone 1 or 2. Busy tone 2 has a unique pattern allowing
users with automatic release SLT's an extended amount of time to enter
codes when encountering a busy party.
When assigned to Yes, the system reminds the user that there is a call on
hold. When disabled there is no reminder tone given to the user. In either
case the call will be disconnected after 30 minutes if it is not retreived.
If "Yes" is selected, a beep tone will be heard when executing Busy
Override or Barge-in. If "No" is selected, there will not be any tone
heard when Busy Override or Barge-in is executed.
Assigns external pagers 1 and 2 .
Either Internal or External Music Source can be used depending on the
selection of the Music Source Selector Switch.
See section 2-D-2.00 "External Music Source", for further information.
This assignment applies to a PITS telephone when "Idle Line Preference-
Calling" is assigned on it. If "DN" is selected, an idle DN button is auto-
matically seized by simply going off-hook, and an idle CO button is seized
automatically if "CO" is selected.
Assigns the FDN (Floating Directory Number) for General Operator Call.
This is used for the following attendant-seeking calls: DID, DISA, Call
Forwarding and Overflowed UCD calls.
There are two entries to allow for two tenants.
Assigns the self-PBX code which is used when accessing the TIE line.
10-D-3