Table of Contents
Advertisement
Installation: Inspection And
Adjustment After Installing
3. Adjust the direction of the warning light
✽ This is attached to the left wheel.
4. Adjust the angle of the battery.
Battery bracket
Tighten with the tightening torque specified
on page 4.
Battery bracket
5. Adjust the length of wire harness.
Be careful not to tighten the clamp exces-
sively, causing bending.
16
Inspection Points and
Adjustment Points
(LED).
Turn the warning light with your finger until it
can be easily seen when sitting in the wheel-
chair.
If the battery is sharply tilted, it is difficult to
remove it.
Procedure 1) Remove the right wheel.
2) Remove the plate cover. (2
screws)
3) Remove the 3 screws of the
battery fitting plate.
4) Shift the position of the bat-
tery fitting plate by discon-
necting the largest connector.
5) Change the position by re-
moving the three battery
bracket fixing bolts.
CAUTION:
If the wire harness is loose, pull it inside the
cover and clip it with the supplied clamp
(90465-10098).
CAUTION:
Hide quick links:
Advertisement
Table of Contents
