Advertisement
DCH-G020
Z-Wave Main Page
This page allows the user to do the advanced Z-Wave configuration of DCH-G020.
Z-Wave Basic Commands:
1.
Include NEW Device / Exclude Device: A device must be "included" to the Z-
Wave network before it can be controlled via Z-Wave(DCH-G020). This process
(also known as "pairing" and "adding") is achieved by pressing/(hold for 5
seconds) "Wireless button" on DCH-G020 or pushing the [Include NEW
Device]([Exclude Device]) button on GUI being into the inclusion(exclusion) mode.
(How to add/remove another Controller (a secondary Controller): same as
including a Z-wave node.)
2.
Learn Mode: Starts learn mode for DCH-G020 if it is needed to include it in
another controller's network.
3.
Reset Z-Wave Controller: Reset the Z-Wave controller only.
4.
This product can be included and operated in any Z-Wave network with other Z-
Wave certified devices from other manufacturers and/or other applications. All
non-battery operated nodes within the network will act as repeaters regardless of
vendor to increase reliability of the network.
Status and Information:
Node ID: Display the node ID of the DCH-G020
Home ID: Display the current Home ID of the DCH-G020
Data Sheet
Page 12
D-Link Corporation
2/11/2015
Advertisement
