Homeowner or contractor installation WARNING: • Refer to this Quick Installation Guide to install Fujitsu Wi-Fi Wireless Device IS-IR-WIFI-1 only. This guide does NOT replace any installation manual(s). • Have contractors refer to the installation manuals that accompany this unit for complete and specific installation details and requirements.
Set up Wireless Device FJ-IR-WIFI-1NA You need the following: • IntesisHome Device • Wi‐Fi Device (laptop/smartphone/tablet) • Access Point or Router • Quick Start Guide/ Install manual Before starting 7Ft Max Check Wi‐Fi Signal strength on the Get close to the device placement location. • If you have enough Wi-Fi signal then proceed to install. • If you don’t have enough Wi-Fi signal: a. Try to install the IntesisHome device in other place b.
Page 3
Set up ihconfig.com Go to Set up Select your Wi‐Fi network Insert Password Click Next...
Page 4
Set up Device will blink in the sequence below: *Note: If the device cannot connect to the router/access point. Please go back to step number one and start again. Once the device is connected to your wireless network. Make an account and register the device on user.intesisHome.com *Note: A confirmation email will be send to you. Follow the instructions before moving to the next step. IR Configuration Once you have the IntesisHome device installed and Wi‐Fi configured, you are ready to start the IR Configuration process. Learning mode is use to provide the end user a quick way to set up their IR wireless connection in seconds. NOTE: Make sure that the AC unit is Off and the Fujitsu wireless Controller is Off before pressing the On/Off button. In order to ensure the learning process, please make sure you send an On command from your Fujitsu Wireless controller. Make sure your wireless remote controller has fully charge batteries. 1) Fujitsu wireless remote controller is off, only time should be display in the remote controller. 2) Press and hold the black button on the back of the Wi‐Fi module for 4 seconds . Top LED will turn on steady white. 3) Press Start Stop on your Fujitsu wireless remote controller while pointing to the Wi‐Fi module. Refer to picture A: • If the IntesisHome device LED starts blinking Green, the IR learning process has been successful. • If the IntesisHome device LED starts blinking in Red, repeat the process from step 1 and check our compatibility list. If problem still persists, please visit our support section at 3ft Max 3ft max www.fujitsugeneral.com/wifi.htm • If the IntesisHome device LED turns Off, repeat the process from step 1 and check that your IR wireless remote controller has batteries and that you are pointing directly to the IntesisHome IR ...
Page 5
Wireless module LED Definitions WPS: Wi‐Fi Protected Setup.
Page 6
Multi‐Zone and HFI Applications Applications with multiple indoor units, each indoor unit must have its own Intesis Wi‐Fi module to manage each zone independently through one account. • Room 4 Room 1 Room 2 • Room 1 • Room 3 • Room 2 Room 3 Room 4 Multi‐Zone Application: Steps to Register New (additional) Devices Click 1) In your IntesisHome account click on the settings option 2) Click on Devices Click 4) Fill and verify code. Code is located on the 3) Click on Add a Facility. Fill all information needed then Click on the device or in the products box. Follow the same plus sign procedure if you have more than one module in your installation. Click Click...