Device will blink in the sequence below:
*Note: If the device cannot connect to the router/access point.
Please go back to step number one and start again.
Once the device is connected to your wireless network.
7
7)
*Note: A confirmation email will be send to you. Follow the instructions before moving to the next step.
8
Once you have the IntesisHome device installed and Wi‐Fi configured, you are ready to start
the IR Configuration process. Learning mode is use to provide the end user a quick way to set
up their IR wireless connection in seconds.
NOTE: Make sure that the AC unit is Off and the Fujitsu wireless Controller is Off before pressing the On/Off button. In order to ensure the
learning process, please make sure you send an On command from your Fujitsu Wireless controller. Make sure your wireless remote
controller has fully charge batteries.
1) Fujitsu wireless remote controller is off, only time should be display in the remote
controller.
2) Press and hold the black button on the back of the Wi‐Fi module for 4 seconds . Top LED
will turn on steady white.
3) Press Start Stop on your Fujitsu wireless remote controller while pointing to the Wi‐Fi
module. Refer to picture A:
A
3ft Max
3ft max
Set up
Make an account and register the device on
user.intesisHome.com
IR Configuration
• If the IntesisHome device LED starts blinking
Green, the IR learning process has been
successful.
• If the IntesisHome device LED starts blinking in
Red, repeat the process from step 1 and check our
compatibility list. If problem still persists, please
visit our support section at
www.fujitsugeneral.com/wifi.htm
• If the IntesisHome device LED turns Off, repeat
the process from step 1 and check that your IR
wireless remote controller has batteries and that
you are pointing directly to the IntesisHome IR
receiver.