Location And Function Of Controls; System Requirements - LG GDR-8162B User Manual

English
Features
• E-IDE interface
• Data transfer rate (DVD-ROM max-16X-speed:
22,100KB/sec, CD-ROM max-48X-speed :
7,200KB/sec)
• Motorized tray loading system
• Designed for internal mounting
• Emergency eject support
• Supports Windows 95, 98, 2000, ME & XP
Plug-and-Play ATAPI protocol
• Read compatible for DVD-R, DVD+RW, DVD-RW
& DVD-RAM discs
• Supports Region playback control Phase II

System Requirements*

• IBM PC AT or compatible, Pentium-266MHz
processor or higher (higher recommended).
• A minimum of 16MB memory
(higher recommended).
1 /
• A suitable free standard 5
• MS-DOS version 3.1 or higher. (Windows 95 and
above recommended).
1 / "
• 3 1.44 MB Floppy Drive.
2
• An existing IDE controller with an available cable
connector or a new IDE controller (recommended
with IDE PIO Mode 4 capability) that you will need
to install.
* Please note: Certain software (i.e. particularly
those including Video playback) may require a
considerably increased specification PC to give
acceptable results. While this DVD-ROM drive can
read DVD-video discs, decoding them to display on
your pc's monitor requires separate MPEG decoding
that is done by separate hardware (either an MPEG
decoder card or MPEG decoding done by your
video card), or separate software that you install to
do MPEG decoding. These items are separate and
are not included with this DVD-ROM drive.

Location and Function of Controls

Front Panel
1. Disc Tray
2. Drive activity indicator
3. Emergency Eject Hole
4. Stop/Eject Button
Rear Panel
1. Digital Audio Output Connector
This connector is not supported.
2. Analog Audio Output Connector
3. Jumper Connector
This jumper determines whether the drive is
configured as a master or slave. Changing the
master-slave configuration takes effect after
power-on reset.
4. IDE Interface Connector
Connect to the IDE (Integrated Device Electronics)
Interface using a 40-pin flat IDE cable.
NOTE : Do not connect or disconnect the cable
when the power is on, as this could cause a short
circuit and damage the system. Always turn the
"
internal drive bay.
4
power OFF when connecting or disconnecting the
cable.
5. Power Connector
Supplied Accessories
z Owner's Manual z
z z Screw (4 pieces)
z z Audio Cable
A