DeWalt D26676-XE Instruction Manual page 7

Adjusting the Depth of Cut (Fig. 2)
Turn the planing depth adjustment knob (D).
One revolution of the adjustment knob equals a 1.5 mm change in depth. Each click
of the adjustment knob represents 0.1 mm of depth, and will increase up to 1.0 mm
in depth.
FIG. 2
D
F
Attaching and Removing the Parallel Fence (Fig. 3)
The parallel fence (L) is used for optimum tool control on narrow workpieces.
1. Loosen the wing parallel fence tightening bolt (F).
2. Fit the parallel fence (L) into hole (G) from either side.
3. Tighten the parallel fence tightening bolt.
4. To remove the parallel fence, proceed in reverse order.
Removing the Blades (Fig. 4)
1. Remove the three bolts (M) with the spanner (N) supplied.
2. Push the side guard (H) up.
3. Remove drum cover (Q) and remove the blade (O) from its holder.
4. Sharpen or replace the blades. To sharpen blades, see Sharpen Blades.
NOTICE: Risk of property damage. Always replace both blades.
5. Replace the drum cover (Q). Make sure the blade is flush with the planing shoe
(P).
6. Tighten the three bolts (M).
FIG. 3
L
G
FIG. 4
O
N
H
M
Adjusting Blades (Fig. 5)
1. Place the blade (O) on the gauge (R), and make sure the blade edge is perfectly
flush with the inside edge of the gauge (R).
2. Place the bracket (S) on the blade, and make sure the flange of bracket is flush
with the back side of the gauge.
3. Tighten the two screws (T) on the bracket.
4. Place the flange of the bracket into the groove of drum (U).
5. Replace the drum cover (Q) and tighten the three bolts (M).
FIG. 5
O
T
S
R
5
M
Q
S
O
U
P
M
Q
T
S
O
U