Reset Procedure - Sharp ER-A770 Dealer Knowledge Book

RESET PROCEDURES
1. Program (SRV) Reset:
To perform a Program Reset, the Reset switch located beneath the back cover panel must be
used. Please refer to (fig. 4) when performing the below key sequence.
(1) Turn the AC power "OFF" using the power switch on the RH-side of the ER-A770.
(2) Place the Reset Switch to the "ON" position (towards the rear).
(3) Turn the AC power to the "ON" position.
(Please note that the display goes out)
(4) Count for 5 seconds.
(5) Place the Reset Switch to the "OFF" position (towards the front)
(Please note that the display becomes lit.
Failure to adhere to one of the above procedures when instructed to do so may result in corrupt
Designs and specifications are subject to change without notice.
or broken RAM addressing
Getting Started Getting Star Getting Star Getting Star Getting Star
(F .4)
IG
Page / 5
ted ted ted ted