Table of Contents
Advertisement
Figure 17 Switch Management GUI
4.
Change the IP address and other settings of the switch as appropriate for your network. You
may also rename the switch or perform other configuration activities at this time.
5.
Remove the Ethernet cable from the first switch and connect the cable to the Ethernet port (2,
Figure 16 (page
the Controller 2 switch and repeat 4.
NOTE:
switch, be aware that two switches cannot have the same domain ID in the same fabric.
Verify the operating status of the servers
Although the EVA is not yet visible to the server, verify that the server is operating properly. A
simple test is to verify that your operating system loaded and then open a software application or
your browser.
If your server is not operating properly, see the documentation that came with the server for help.
24
Turn on power
23)) of the other embedded switch. Browse to http://10.77.77.78 for
If you are renaming or performing other configuration activities on the Controller 2
Advertisement
Table of Contents
