Table of Contents
Advertisement
Changing Hard Disk Drive Passwords
Use the following procedure to change hard disk drive passwords.
Boot your system. Press
1.
At the Main Menu screen, select the Security Menu.
2.
Highlight
3.
T
T
T
Save the changes and exit BIOS Setup.
4.
Using Hard Disk Drive Password Protection
To facilitate the transfer of one or more HDDs between systems, establish
a single master password (and store the password in a secure place).
Forgetting the master password results in the inability to access the data
on the hard drive. Establish different user passwords to limit access to
specific systems.
hard drive, you can never remove the passwords. You can change the
passwords. If you forget the master password and install the drive in
another system, you cannot access the data on the hard drive.
Once you set these passwords, NEC Computers Inc. has no
capability of removing them.
If you install the hard drive in another PowerMate system with hard disk
drive security enabled, you must enter the password to allow access to the
hard drive. If this PowerMate system does not support hard disk drive
security, you cannot access the data on the hard drive.
With hard disk drive security enabled on the original NEC PowerMate
2000 series system, the system boots normally.
3-26 Configuring the System
Assign HDD Password
If you enter the current master password, you are prompted to
enter a new master password.
If you enter the current user password, you are prompted to enter
the new user password.
If you do not want to establish a new master or user password,
press
instead of entering a new password.
Esc
If you set the master and user password on a
when prompted to enter BIOS Setup.
F2
and press
.
Enter
Advertisement
Table of Contents
