NEC AccuSync LCD22WMGX, AccuSync LCD24WMCX User Manual page 17

Controls Controls
OSD MESSAGE
1). When an analog signal is displayed, and the "AUTO" button is pressed, this
Auto Confi g.
message will appear while the display is performing the Auto Confi guration.
2). This message does not appear when digital signals are used.
Please Wait
Input Not When the Hsync Frequency, Vsync Frequency or Resolution is out of the monitor's
support range, will show this message.
Supported
When the video cable is not connected, or the video cable is connected but there
No
is no active signal input, this message will appear. After 9 seconds the monitor will
Signal
enter power saving. This message location is at the position setting in "OSD Setup"
item.
When the OSD is unlocked, hold down the "Menu" key and press the "Power"
key simultaneously to turn on the monitor, the OSD will be locked and show this
message.
When the OSD is locked, only the Power key functions are still working. If other
OSD Locked
keys are pressed, the OSD Locked" message will appear.
When the OSD is locked, hold down the "Menu" key and press the "Power" key
simultaneously to turn on the monitor, the OSD will be locked and show this mes-
sage.
1.) D-SUB: Analog PC source is selected.
2.) DVI: Digital PC source is selected.
Input Signal
3.) YPbPr: Analog Video source (Component) is selected.
4.) HDMI: Digital Video source (HDMI) is selected.
–continued –continued
15