Theatersync Operational Modes - NEC TheaterSync Video Processor User Manual

TheaterSync Video Processor User Manual
The Operate/Setup button toggles the TheaterSync between "Operate" and "Setup" modes of
operation (as described in the next section of this User Interface chapter).
The Menu button is used to invoke the OSM main menu.
The Up/Down/Left/Right Arrow buttons are used to navigate the
The Enter/Select button is used to activate an OSM menu selection.
Direct (one-touch) input selection is possible using the buttons below:
• The RGB button selects the VGA port as the active input.
• The DVI button selects the DVI port as the active input.
• The Video button selects the composite video port as the active input.
• The S-Video button selects the S-Video port as the active input.
• The YPbPr button selects component video as the active input.
• The HDMI button selects HDMI as the active input.
• The SDI button selects the SDI port as the active input
Additional buttons are available to directly access key video processing features and to cycle
through the available enhancements:
• The BCE button activates/deactivates the Brightness / Contrast Enhancement feature
• The Aspect Ratio button cycles through and selects the available aspect ratio treatments
available for the current input and output mode combination (for description of aspect
ratio treatments, see section 5.2)
• The TRNR button accesses the Temporal Recursive Noise Reduction feature, cycling
through the four available settings (Off, Low, Medium, and High)
• The CNR button accesses the Codec Noise Reduction feature, cycling through the four
available settings (Off, Low, Medium, and High)
• The Film button cycles through the three available film mode treatments for active video
(Auto Film/Video mode detect, Force to Video mode, Force to Film mode)
• The Split button activates/deactivates a split-screen mode for direct comparison of the
image with and without noise reduction activated.
4.2

TheaterSync Operational Modes

TheaterSync has two operational modes, Operate and Setup. These modes are selected by a
dedicated key on the IR remote. TheaterSync also enables selection of the Operate Mode with
RS-232, USB, or Ethernet.
NEC Solutions, Inc.
MKT-0026-UMN-1.002F
.
OSM
Page 17