Sony LMD-940W Operating Instructions Manual page 26

Submenu
PARALLEL REMOTE
26
Adjustment Using the Menus
Setting
Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – ("– – –": No function is
assigned.)
• COMPOSITE
• SDI
• HDMI
• OVERSCAN
• FULL
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R
• TALLY G
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• MARKER MAT HALF
• MARKER MAT BLACK
• WFM/ALM
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 29.
• Set MARKER ENABLE
(page 22) to ON to control the
aspect marker and center
marker.
Submenu Setting
SERIAL REMOTE Selects the mode to be used.
• OFF: SERIAL REMOTE does
• ETHERNET: The monitor is
• BKM-15R: Sets BKM-15R.
MONITOR Sets the monitor setting.
CONTROLLER Sets the address of the remote
controller.
CONNECTION Sets the connection of the monitor
and the controller.
not function.
controlled by the command
of Ethernet.
MONITOR ID: Sets the ID
of the monitor.
GROUP ID: Sets the group
ID of the monitor.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.
PEER TO PEER: for one
to one connection
LAN: for connection via a
network