Connecting The Power - D-Link DNS-1250-04 Quick Installation Manual

To connect and power up the NAS system:
1. Attach the power cord on the back of the enclosure
2. Plug the other end into your power source.
3. On the front of the NAS system, press the Power
Button.
It takes about a minute to boot up. When fully booted:
• The System Status LED turns blue.
• The buzzer beeps one time.
4. Network Configuration with the LCD Screen
The DNS-1250-04 and DNS-1250-06 NAS systems have an LCD screen on the front panel that
enables you to monitor system status and configure the network
To configure the networking settings:
1. Press the Enter button to display the Network Setup option.
2. Press the Select button to choose each option.
3. Then press the Enter button to change the setting values.
4. When you are done, choose OK and press the Enter button
to apply the networking configuration.
8

3.3 Connecting the Power

D-Link DNS-1250-04 & DNS-1250-06 Quick Installation Guide
Power Connector
Power Button /
System Status LED
Select button
Enter button