Table of Contents
Advertisement
Setting
• Select this setting when
using special tape.
• When using Fabric Tapes or
Heat Shrink Tube, set
[Special tape] for [Cut
Option] before printing.
After printing, remove the
tape cassette from the
Special
P-touch and use scissors to
tape
cut the tape.
NOTE
• When the cut option is set to [No Cut] or [Chain], it stops in the middle
of printing area after the last label is printed. After [OK to Feed?] is
displayed, press (
to the text entry screen.
• When the cut option is set to [Large Margin], [Small Margin], [Chain],
after printing the message [Cut tape or press Enter to continue.] is
displayed and the P-touch goes into the cut pause mode. By pressing
the Tape cutter lever, you can cut the tape at the position you set in
[Cut Option].
Adjusting the Label Length
When the tape cassette comes to the end, the printed length may be less
accurate.
In this case, you can adjust the label length.
(
)
/
[Settings]
(
)
/
or (
).
NOTE
Approximately 1 % of the total label length will be adjusted by 1 level.
Description
) or (
(
) or (
[Label Length]
• When multiple copies are printed one
time:
23.9 mm
• When a label is printed two times:
ABC
23.9 mm
1. 1st print
2. 2nd print
) to feed the tape. Press (
)
/
[Adjustment]
(
) or (
)
LABEL PRINTING
Example
ABC
ABC
4 mm
1
ABC
27.9 mm
) to return
(
/
[-5 - +5]
Adjusting the Label Length
4 mm
2
) or
(
)
36
Advertisement
Table of Contents
