Philips InfraCare HP3631 User Manual page 10

ENGLISH
10
Battery
The battery compartment of the timer is located in a recess in the back of the appliance.
1 Remove the cover of the battery compartment by turning it to the left with a screwdriver.
2 Insert a new battery. Make sure the - and the + poles of the new battery are pointing in the
right direction.
Note: We advise you to use a 1.5V alkaline button battery, type LR54.
3 To close the battery compartment, put back the cover and turn it to the right with a screwdriver.
Recycling
Do not throw away the product with the normal household waste at the end of its life, but hand it
in at an official collection point for recycling. By doing this, you help to preserve the environment.
Guarantee and support
If you need information or support, please visit www.philips.com/support or read the separate
worldwide guarantee leaflet.
Troubleshooting
If the appliance does not work or does not work properly, first check the list below. If the problem
is not mentioned in this list, the appliance probably has a defect. In that case we advise you to
contact the Philips Consumer Care Centre.
Problem
The appliance
does not go on.
Cause
The plug has not been
inserted properly into the
wall socket.
There may be a power
failure.
The lamp may be defective.
The mains cord of the
appliance may be damaged.
Solution
Insert the plug properly into the wall socket.
Check if the power supply works by
connecting another appliance.
Contact the Philips Consumer Care Centre.
Check the mains cord. If the mains cord is
damaged, it must be replaced by Philips or
similarly qualified persons in order to avoid a
hazard.