Bosch GWS 21-180 H Operating Instructions Manual page 15

Machine Elements
1 Thread for auxiliary handle (3x)
2 Spindle lock
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protective guard
7 Adjustment screw
8 Clamping lever
9 Mounting flange with O-ring
10 Roughing/cutting disc*
11 Clamping nut
12 quick clamping nut*
13 Clamping screw
14 Coded projection
* Optional accessories
* Not all of the accessories illustrated or described are included as standard delivery.
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the en-
closed booklet must be ob-
served. Before using for the first
time, ask for a practical demon-
stration.
If the mains cable is damaged or
cut through while working, do not
touch the cable but immediately
pull the mains plug. Never use the
machine with a damaged cable.
Wear protective glasses and ear
protection.
The dust that is produced while
working can be detrimental to
health, inflammable or explosive.
Suitable safety measures are re-
quired.
Examples: Some dusts are re-
garded as carcinogenic. Use suita-
ble dust/chip extraction and wear a
dust mask.
16 • 1 609 929 C63 • TMS • 25.07.01
15 Guard, grinding cup*
16 Grinding cup*
17 Hand protector*
18 Spacers*
19 Rubber sanding plate*
20 Sanding disc*
21 Round nut*
22 Cup brush*
23 Diamond cutting disc*
24 Cutting guide with protective vacuuming
hood*
25 Handle unlocking button
26 Handle
27 Cutting grinder stand*
Dust from light alloys can burn or explode. Al-
ways keep the work place clean, as blends of ma-
terials are particularly dangerous.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always direct the cable to the rear away from
the machine.
Always switch off the machine and allow to
come to a stop before placing it down.
Insert the mains plug only when the machine is
switched off.
For mains failure or when the main plug is
pulled, unlock the On/Off switch immediately
and turn it to the off position. This prevents un-
controlled restarting.
The machine must be used only for dry
cutting/grinding.
English - 2
Wear protective gloves and sturdy
shoes.
When necessary, also wear an
apron.