Only For Training And Service Purposes - LG U370 Service Manual

3. TECHNICAL BRIEF
3.2.2 GSM Transmitter
The RTR6275 transmitter outputs(DA_HB2_OUT and DA_LB1_OUT)include on-chip output matching
inductors. The 50ohm output impedance is achieved by adding a series capacitor at the output pins.
The capacitor value may be optimized for specific applications and PCB characteristics based on pass-
band symmetry about the band center frequency, the suggested starting value is shown in Figure1.2.
The RTR6275 IC is able to support GSM 900 and GSM 1800/1900 mode transmitting. This design
guideline shows a tri-band GSM application.
Both high-band and low band outputs are followed by resistive pads to ensure that the load presented
to the outputs remains close to 50ohm. The low-band GSM Tx path also includes a Tx-band SAW filter
to remove noise-spurious components and noise that would be amplified by the PA and appear in the
GSM Rx band
LGE Internal Use Only
6pF 120Ω
91Ω 91Ω
10pF 51Ω
100Ω 100Ω
[Fig 1.3] GSM Transmitter matching
- 22 -
Copyright © 2007 LG Electronics. Inc. All right reserved.

Only for training and service purposes