Camshaft Position (Cmp) Sensor Removal And Installation - Suzuki SX4 Service Manual

Installation
Reverse removal procedure noting the following.
• Tighten heated oxygen sensor (1) to specified torque.
Tightening torque
Heated oxygen sensor (a): 45 N·m (4.5 kgf-m,
32.5 lb-ft)
• Install exhaust manifold referring to "Exhaust Manifold
Removal and Installation in Section 1K", if removed.
• Connect connector of heated oxygen sensor (1) and
clamp wire harness securely.
• After installing heated oxygen sensor, start engine
and check that no exhaust gas leakage exists.
[A]
1, (a)
[B]
[A]: HO2S-1
1, (a)
I3RM0A130007-01
[B]: HO2S-2
Engine Electrical Devices:
Camshaft Position (CMP) Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect connector from CMP sensor.
3) Remove camshaft position sensor from timing chain
cover (non-VVT model) or cylinder head (VVT
model).
Installation
1) Install camshaft position sensor to timing chain cover
(non-VVT model) or cylinder head (VVT model).
Tightening torque
CMP sensor bolt (non-VVT model) (a): 10 N·m (
1.0 kgf-m, 7.5 lb-ft)
CMP sensor bolt (VVT model) (b): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
[A]: Non-VVT model
2) Connect connector to CMP sensor securely.
3) Connect negative cable to battery.
1C-8
S7RW0A1306012
I6RW0D130002-02
[B]: VVT model