Camshaft Position (Cmp) Sensor Removal And Installation; Camshaft Position (Cmp) Sensor Inspection - Suzuki 2006 SX4 Service Manual

Camshaft Position (CMP) Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect connector from CMP sensor.
3) Remove camshaft position sensor from timing chain
cover (non-VVT model) or cylinder head (VVT
model).
Installation
1) Install camshaft position sensor to timing chain cover
(non-VVT model) or cylinder head (VVT model).
Tightening torque
CMP sensor bolt (non-VVT model) (a): 10 N·m (
1.0 kgf-m, 7.5 lb-ft)
CMP sensor bolt (VVT model) (b): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
[A]: Non-VVT model
2) Connect connector to CMP sensor securely.
3) Connect negative cable to battery.
S6RW0D1306012
I6RW0D130002-02
[B]: VVT model
Engine Electrical Devices:

Camshaft Position (CMP) Sensor Inspection

Visual check
• Check that O-ring is free from damage.
• Check that end face of sensor and signal rotor tooth
are free from any metal particles and damage.
1C-9
S6RW0D1306013
I4RS0B130015-01