Steering Lower Shaft Removal And Installation - Suzuki 2006 SX4 Service Manual

Steering Lower Shaft Removal and Installation

CAUTION
!
Never turn steering wheel while steering
lower shaft is removed.
Should it have been turned and contact coil
have got out of its centered position, it needs
to be centered again. Also, turning steering
wheel more than about two and a half turns
will break contact coil.
Removal
1) Turn steering wheel so that vehicle's front tires are at
straight-ahead position.
2) Turn ignition switch to LOCK position and remove
key.
3) Remove steering joint cover.
4) Make alignment marks (4) on lower shaft (1) and
pinion shaft (3) for a guide during reinstallation.
5) Remove lower shaft upper and lower joint bolts (2).
6) Remove steering lower shaft (1).
1
1
2
4
3
Installation
S6RW0D6206012
1) Be sure that front wheels are in straight forward
state.
2) Align flat part "a" of steering lower shaft (1) with bolt
hole "b" of shaft joint (2) of column as shown. Then
insert lower shaft into shaft joint of steering column.
3) Insert lower shaft (1) into pinion shaft (3) with
matching marks (4).
4) Tighten lower joint bolt (6) to specified torque first
and then upper joint bolt (5) to specified torque.
Tightening torque
Steering lower shaft assembly upper joint bolt
(a): 25 N·m (2.5 kgf-m, 18.5 lb-ft)
Steering lower shaft assembly lower joint bolt
(b): 25 N·m (2.5 kgf-m, 18.5 lb-ft)
2
I5RW0A620008-01
Steering Wheel and Column:
2
"b"
"a"
1
6, (a)
4
3
6B-10
5, (a)
I5RW0A620009-02