P/S Control Module Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove console box.
3) Disconnect connectors (1) from P/S control module.
4) Remove P/S control module and bracket (2) from
floor panel.
5) Separate P/S control module and bracket.
Installation
Reverse removal procedure.
S6RW0D6306011
1
2
I5RW0A630027-01
Power Assisted Steering System:
Torque Sensor and Its Circuit Inspection
1) Check that torque sensor circuit is in good condition
referring to Step 2 to 3 of "DTC C1111 / C1113 /
C1115: Torque Sensor Circuit Failure". If check result
is not satisfactory, repair torque sensor circuit.
2) Remove console box.
3) With ignition switch turned OFF, connect scan tool to
DLC or connect voltage tester between "E11-18" –
"E11-9" (main sensor) or "E11-10" – "E11-9" (sub
sensor) with connected connector to P/S control
module.
[A]
E11
[B]
E11
[A]: Main sensor
4) Set torque wrench to steering wheel referring to
"Steering Force Check" for checking steering force.
6C-41
S6RW0D6306012
18
18
9
10
9
I7RW01632021-01
[B]: Sub sensor
I3RM0A630022-01