Transmission Control Module (Tcm) Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

5A-76 Automatic Transmission/Transaxle:
Not using regulated DC power supply
1) Connect pressure control solenoid valve (1) to
battery (2) setting the 8 – 10 W bulb (4) on the way
as shown in the figure.
2) Check for movement of valve (3) in the direction of
arrow "A".
3) Disconnect pressure control solenoid valve (1) from
battery (2) and check movement of valve (3) in the
direction of arrow "B" as shown in the figure.
CAUTION
!
Set 8 – 10 W bulb on the way, or pressure
control solenoid valve is burned out.
1
4
8-10 W
2
1
4
8-10 W
2
3
A
3
B
I3RH0B510029-01
Transmission Control Module (TCM) Removal
and Installation
CAUTION
!
TCM consists of highly precise parts,
therefore when handling it, be careful not to
expose to excessive shock.
Removal
1) Disconnect negative cable at battery.
2) If the vehicle is equipped with air bag system,
disable air bag system. Refer to "Disabling Air Bag
System in Section 8B in related manual".
3) Remove parking brake cover, console box (1) and
console covers (2).
4) Disconnect connectors (3) from TCM (4).
5) Remove TCM (4) by removing its bolts (5).
3
4
5
Installation
Reverse removal procedure noting the following.
• Connect TCM connectors securely.
• If the vehicle is equipped with air bag system, be sure
to enable air bag system after TCM is back in place.
Refer to "Enabling Air Bag System in Section 8B in
related manual".
S3RH0B5106018
2
1
I2RH01510074-01