Fuel Tank Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

Installation
For installation, reverse removal procedure and note the
following precautions.
• Use new O-ring (1).
• Apply thin coat of gasoline to O-ring to facilitate
installation.
• Tighten fuel pressure regulator bolts to specified
torque.
Tightening torque
Fuel pressure regulator bolt (a): 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
• With engine OFF and ignition switch ON, check for
fuel leaks around fuel line connection.

Fuel Tank Removal and Installation

Removal
1) Relieve fuel pressure in fuel feed line according to
2) Disconnect negative cable at battery.
3) Remove fuel filler cap.
4) Insert hose of a hand operated pump into fuel filler
I2RH0B170015-01
(a)
5) Hoist vehicle.
6) Remove muffler referring to "Exhaust Pipe Removal
7) Remove EVAP canister with its bracket (1) from
I2RH0B170016-01
WARNING
!
Before servicing fuel system, be sure to
observe "Precautions on Fuel System
Service in related manual".
"Fuel Pressure Relief Procedure in related manual".
hose (1) and drain fuel in space "A" in the figure.
CAUTION
!
Do not force pump hose into fuel tank, or
pump hose may damage fuel tank inlet valve
(2).
and Installation in Section 1K in related manual".
vehicle.
1
Fuel System: 1G-5
S3RH0B1706012
I3RH01170029-01
I2RH01170009-01