Dtc P0105 (No. 11): Manifold Absolute Pressure (Map) Circuit Malfunction - Suzuki Liana RH418 Supplementary Service Manual

Step
7 Check oil control valve
1) Check oil control valve referring to "Oil Control Valve
Inspection in Section 1C".
Is it in good condition?
NOTE
Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and confirm
that the trouble has been corrected.

DTC P0105 (No. 11): Manifold Absolute Pressure (MAP) Circuit Malfunction

Wiring Diagram
DTC Detecting Condition and Possible Cause
DTC detecting condition
• MAP sensor signal is 0.19 V or lower
(Low pressure – High vacuums – Low voltage)
or
• MAP sensor signal is 4.5 V or higher
(High pressure – Low vacuums – High voltage)
NOTE
• When this DTC and DTC P0120 (No. 13) are indicated together, it is possible that "GRY/RED" circuit
is open.
• When DTC P0105 (No. 11), P0110 (No. 18), P0115 (No. 19) and P0120 (No. 13) are indicated together, it
is possible that "ORN" circuit is open.
Action
AMP
C41 (31P)
9 8 7 6 5 4 3 2 1
21 20 19 18 17 16 15 14 13 12 11 10
31 30 29 28 27 26 25 24 23 22
1. To TP sensor
2. From other sensors
Engine General Information and Diagnosis:
Replace camshaft
timing sprocket.
1
GRY/RED
LT GRN/RED
ORN
2
G04 (24P)
7 6 5 4 3 2 1 6
12
16 15 14 13 12 11 10 9 8
24 23 22 21 20 19 18 17 17
• "ORN" circuit open
• "GRY/RED" circuit open or shorted to ground
• "LT GRN/RED" circuit open or shorted to ground
• MAP sensor malfunction
• ECM malfunction
Yes
Replace oil control
valve.
ECM
5V
5V
C41-22
C41-26
C41-10
G03 (17P)
5 4 3 2 1
11 10 9 8 7
16 15 14 13
Possible cause
1A-46
No
S3RH0B1104016
I2RH0B110022-01