Select Cable Removal And Installation; Selector Lever Components; Selector Lever Inspection - Suzuki Liana RH418 Supplementary Service Manual

5A-66 Automatic Transmission/Transaxle:
5) Lower vehicle and fill proper amount of an equivalent
of DEXRON ® -III.
6) Check fluid level referring to "A/T Fluid Level Check".
Automatic transaxle fluid
An equivalent of DEXRON
Automatic transaxle fluid capacity
When draining from drain plug hole: 2.9 liters
(6.13/5.10 US/Imp. pt.)
When overhauling: 6.2 liters (13.10/10.91 US/Imp.
pt.)
1 3
4
1. Fluid level gauge
2. "FULL HOT" mark
3. "LOW HOT" mark
4. Fluid level

Select Cable Removal and Installation

Removal
1) Remove parking brake lever cover.
2) Remove console box.
3) Disconnect select cable from selector lever and then
detach from bracket.
4) Remove clip and disconnect select cable from
manual shift.
5) Remove select cable retainer from dash panel.
Installation
Install select cable by reversing removal procedure.
The important steps in installation are as follows.
• Apply grease to pin and cable joint.
• Tighten bolts in upper figure to specified torque.
• Adjusting procedure is as follows.
® -III
1
2
I3RH0B510023-01
S3RH0B5106003

Selector Lever Components

3 N·m (0.3 kg-m)
3
4
1. Selector lever assembly
2. Knob assembly

Selector Lever Inspection

Check select lever for smooth and clear-cut movement
and position indicator for correct indication.
For operation of select lever, refer to the figure of
"Selector Lever Components".
S3RH0B5106004
2
2.5 N·m (0.25 kg-m)
1
I3RH0B510007-01
3. Indicator assembly
4. Illumination lamp
S3RH0B5106005
I3RH0A510022-01